Plank Flash
Custom sizes available to fit your specifications !
Product Detail
Design Features
Use to prevent moisture from penetrating behind the joint where two
planks butt together. Pre-cut for quick and easy installation. Conveniently
clips to your belt.
Installation
The recommended method for butting factory-finish ends for all
HardiePlank® lap siding is moderate contact over a piece of joint flashing. This method is required for joining ColorPlus® lap siding products.
Flashing behind butt joints provides an extra level of protection against the
entry of water at the joint. James Hardie recommends 6" wide flashing that
overlaps the course below by 1". Some local building codes may require
different size flashing.
James Hardie does not recommend the use of caulk at field butt joints.
James Hardie does not recommend the use of caulk at field butt joints.
Material
3105-type aluminum sheet coated on both sides with Dymalar® 2000 paint
system that is specifically formulated for residential exterior applications.