Z Flashing
Custom sizes available to fit your specifications !
Product Detail
Design Features
Z Flashing provides an easy to install and long-lasting method of stopping
water penetration. Z Flashing is designed for residential and light
commercial applications. Used over window trim, band boards, panel
intersections, and other vertical surfaces.
Installation
After installing the lower course of panel siding, install Z flashing at the
top edge of the panel. Make sure that the Z flashing is sloped away from
the wall and does not rest flat on the top edge of the panel. Install the
second level panels leaving a 1/4-in. minimum gap between the bottom of
the panel and the Z flashing. This gap should never be caulked.
As an alternative, if a horizontal band board is used at the horizontal joint, flashing must extend over the panel edge and trim attachment. Z flashing must slip behind the water-resistive barrier.
As an alternative, if a horizontal band board is used at the horizontal joint, flashing must extend over the panel edge and trim attachment. Z flashing must slip behind the water-resistive barrier.
Material
3105-type aluminum sheet coated on both sides with Dymalar® 2000 paint
system that is specifically formulated for residential exterior applications.